Commercial EPDM Roof Replacement, October 2015, Saskatoon, SK

This client in Saskatoon contracted GRS to send out a crew that could replace their currently flat roof with a new EPDM system. The team went on location to rip out the old system and installed the requested EPDM without any issue.   Roof Report: October 7, 2015 This day, the crew arrived on site for 7:00am and began to rip off the existing roof system. The other team members didn't arrive until a short while later, right around the time that the crane showed up with the site materials. Between 12:30 and 12:45pm, the team loaded the roof and found that the order was missing insulation and seam plates. The site lead had to leave the site then, to pick up the missing supplies. By their return at 3:00pm the remaining team had torn off enough of the roof to expose some rotten plywood underneath. This too, had to be replaced, so another member of the crew was dispatched to pick up some replacement sheets. In the meanwhile, the on-site crew put down the ISO insulation boards and began gluing the rubber to it. It was around that time (~5:00pm) that the temperature began dropping below what the normal threshold for the glue's application permits, so the team weighted down the EPDM for the night and prepared the site for the rubber's adhesion the following day.  
20151007_124904
We started the roof replacement by ripping out the existing system. The roof surface consisted of plywood boards.
20151007_152321
Some of the plywood boards on the roof were rotted to a point where there were holes in the assembly.
20151007_181009
Damaged pieces of plywood were replaced and we prepared to install ISO over the structure.
20151007_185222
Bonding agent was applied to the underside of the EPDM and installed over the ISO boards.
    Roof Report: October 8, 2015 The crew assembled once more for 7:00am and got to ripping out the rest of the roof as the sun began to rise higher into the sky, warming up the site. When the roof itself was all torn out, they laid the EPDM's ISO insulation and then adhered the rubber atop it. This work carried on through the day, so that by the time they were prepared to leave the site, all of the rubber had been laid down and some of the plywood had been installed to the parapet walls where it had required replacing. The following day would only require some detail work to some curbs and seams. They expected that everything would be completed by 3pm and the site would then be entirely finished.    
20151008_170637
After ripping out the existing structure on the second half of the roof, we mechanically fastened ISO boards.
20151008_170709-1
More mechanical fasteners around the perimeter of the roof.
20151008_170720
We applied rubber seam tape over the perimeter of the roof to prepare to install the perimeter flashing.
20151008_175840
Completed flat roof EPDM installation.
      Roof Report: October 10, 2015 The crew finished the roof on this day, but not without a little bit of trouble during the process. One of the subcontractors hired on for the job was not able to carry out the metal work that they'd claimed, so a replacement had to be found on short notice. The replacement arrived on site and completed the metal work in a timely fashion that also measured up to the exacting standards on any GRS project. With the metal work done, the site was cleaned up and the crew departed, leaving this another completed site bearing the GRS stamp of approval.
20151009_174044
To wrap up the site, we finished the metal work, including the perimeter flashing.
< End Report > CODE: 103 Contact Us Call our 24 hour emergency roof repair at 1.780.424.7663. Mail to: 3428 99 Street NW Edmonton, Alberta T6E-5X5. We service all of Alberta including Edmonton, Stony Plain, Spruce Grove, Fort Saskatchewan, St Albert, Sherwood Park, Leduc, Nisku, Beaumont, Lac La Biche, Grande Prairie, High Level, Westlock, Slave Lake, Edson, Drayton Valley, Devon, Camrose, Wetaskiwin, Tofield, Lamont, Morinville, Vegreville, Millet, Calmar, Evansburg, Redwater, Onaway, Viking, Athabasca, High Prairie, Valleyview, Fairview, Peace River, Whitecourt, Mayerthorpe and many more rural areas and towns.

Roof Snow Removal and Leak Repair in Saskatoon, March 2013

Below you will find two field reports for a commercial snow removal in Saskatoon, Saskatchewan. Snow buildup had been implicated as a cause of leaks in the client's office.
March 1 2013:
We arrived on-site in the afternoon and measured the roof, which was a bit larger than our initial estimates. There is a leak in the client's office, so we cleared out about 150 sq. ft. around the leak area (first photo).
Better shovels are on the material list for tomorrow so we can work a lot more efficiently.
image image[1] image[2] image[3]
March 2 2013:
Above the client's office, there are a lot of improperly sealed spots that need work, which are causing the leak. Two segments of the building have had their snow removed in preparation. If the water that leaked into his office is not drained properly, there is going to be a big problem here pretty soon.
image (1) image[2] image[3] image[4] photo
< End Report >
Code: 3910
Contact Us Call our 24 hour emergency roof repair at 1.780.424.7663. Mail to: 3428 99 Street NW Edmonton, Alberta T6E-5X5. We service all of Alberta including Edmonton, Stony Plain, Spruce Grove, Fort Saskatchewan, St Albert, Sherwood Park, Leduc, Nisku, Beaumont, Lac La Biche, Grande Prairie, High Level, Westlock, Slave Lake, Edson, Drayton Valley, Devon, Camrose, Wetaskiwin, Tofield, Lamont, Morinville, Vegreville, Tofield, Millet, Calmar, Evansburg, Redwater, Onaway, Viking, Athabasca, High Prairie, Valleyview, Fairview, Peace River, Whitecourt, Mayerthorpe and many more rural areas and towns.