Edmonton Industrial Flat Roof Replacement, September 2012

This industrial client required a full flat roof replacement with additional work attached to the project. This included painting of vents and painting of the frames that run the perimeter of the building.  Roof Report, September 18, 2012: The crew arrived and began removing the gravel from the rooftop as well as loading the materials into the site area. photo (12) photo (13) photo (14) photo (15) photo (16) photo (17) photo (18) photo (19) Roof Report, September 19, 2012: The crew returned the next day and tore off an area 16 square ft. wide. They then cleaned the roof and covered it ensuring that everything was water proof. photo (27) photo (28) photo (30) photo (31) photo (32) photo (33) photo (36) photo (37) photo (38) photo (39) Roof Report, November 6, 2012: The crew attended the site and installed all of the flashing while also removing any unwanted metal from the rooftop.
photo (1) photo (2) photo (3) photo (4) photo (5) photo
  The client reached out to us regarding the time line of the roof membrane installation. The following emails are between our project manager (italicized) and the client: Are we planning to attempt something tomorrow?  Need to give status of repair job plans by 8AM as they will be bugging me again.  Just to recap they will be asking for more detail on repair job as time stretches on and more detail on backup plans if weather stays cool and wet until snow falls.
Hi, To complete the roof membrane portion we require the roof to be dry on top for at least 24 hours. As such, the weather will determine what day that occurs. Based on the forecast our scheduling is for this Wednesday or Thursday. If for some reason we cannot accomplish this task before freeze up then we will hoard. However, in all our experience with this product we have never had to, we have always, every year completed all scheduled sites before freeze up. The material can be applied to - 10 celcius which gives us ample time. After we have completed the last coat we then have to do metal which can be done in any temperature. When we consulted the manufacturer about the recent moisture after spraying it was made evident that there were a few isolated areas that did not have time to cure and of course moisture penetrated. Also we were advised that any existing moisture in the system would manifest in the form of a blister. If no blisters are present after completion we are good to go. If present, we cut that section out and replace. Thanks.
This article may be updated at a later date. < End Report > CODE: 1515 Contact Us Call our 24 hour emergency roof repair at 1.780.424.7663. Mail to: 3428 99 Street NW Edmonton, Alberta T6E-5X5. We service all of Alberta including Edmonton, Stony Plain, Spruce Grove, Fort Saskatchewan, St Albert, Sherwood Park, Leduc, Nisku, Beaumont, Lac La Biche, Grande Prairie, High Level, Westlock, Slave Lake, Edson, Drayton Valley, Devon, Camrose, Wetaskiwin, Tofield, Lamont, Morinville, Vegreville, Tofield, Millet, Calmar, Evansburg, Redwater, Onaway, Viking, Athabasca, High Prairie, Valleyview, Fairview, Peace River, Whitecourt, Mayerthorpe and many more rural areas and towns.