- 1.5 pails of brush grade LR.
- 3 rolls of seam tape.
- 5 tubes of caulking.
The scope of work is: Supply and install 2 downspouts outside of building. Replace all residential downspouts to industrial (all powder blue). Remove EPDM liner at gutter, vertical up wall 12", and vertical to roof connection on top of roof 12". Build up liquid rubber to slope to each drain. Cap flashing maintenance. Liquid rubber application to seam in the middle of roof (2' x 186'). Liquid rubber application to seam by and up vertical wall (4' x 186'). Liquid rubber to be applied on all penetration. Anything outside of the scope listed above will be considered a change order and additional charges will apply over and above the dollar amount stated in this contract. For this job you will require 4 drums of metalsafe. We may need to bring additional drums of metalsafe from Calgary if there are not enough for use on this job in Edmonton.
This client wants all of the residential downspout replaced with industrial downspout. A total of three downspouts from the upper roof to the lower, and a total of five from the lower roof eavestrough connected to the existing drains and extending through the industrial soffit to the ground. The upper downspouts are fairly straight forward. The lower ones are a little more complex and will require removal of the soffit/siding in the locations of the downspouts/drains (extending the industrial size downspouts through the soffit, then replacing the soffit). The bottom section of downpipes will have to be fastened into stone so a hammer drill will be required to fasten pipe straps. Colour of all the downspouts is to be Slate Blue. You will need a 32' ladder for access. I have compiled a material list needed below, as well I have attached pictures of the project. As before please keep me informed of the estimated start date, and the date you complete the project.