Upon my return we removed the old roof and noticed that there was a lot of rot in the ply wood, so we had to cut it out and replace it with new wood. The area around the skylight was also rotten so we had to rebuild it which took quite a while.
Roof Report, June 29, 2014:
We arrived on site and had our tool box meeting then began to clean the roof. Next we started with our ISO install, once it was fastened down we placed the russ strip on the perimeter. After this was done we started to lay out the rubber which took some time as there are 11 corners, a skylight, and a scupper on this roof. As we were gluing down the rubber I was going behind and down all the corners with flash form.
At the end of the day we resealed the skylight and lap-sealed all of our corners and details. Lastly we cleaned up the site. The back roof is now complete but the dec-tec installation still remains.
Roof Report, July 9, 2014:
When we got to the site we began by cleaning up our work area. Then we started to cut down the stucco and original metal cap flashing so that we could replace the wall substrate. Rain was starting to fall and the roof area was leaking; we built a cover over the roof area so that we could continue without getting a seal.
Roof Report, July 10, 2014:
We removed the old roof, the wall substrate, and floor. Then we went to the dump to get rid of the garbage we had. I was going to go to home depot for the rest of the materials that I needed but it started raining so I just stopped for some more poly to make sure no water got inside. We got the poly up in place and it stopped raining so we continued with the working of the trusses. It is rotten right through on the SE corner of the deck and extra time was needed to repair and cut down some of the trusses. We also had to cut a lot of stucco off the post so that we could get a proper tie in with the dec-tec.
Roof Report, July 11, 2014:
We spent the day replacing the rotten wood around the wall post and repaired the area so that there would not be a problem around the post again. Extra time was spent correcting the slope in the SW corner so that water would not pond there. This included installing 2x4' s at at the right slope and screwing them in from both sides, again all while standing on trusses. We also started on the first run of 5/8 plywood and got half way through lowering the edge for the drip metal to be flush.
Roof Report, July 13, 2014: Today we completed the floor substrate so that there is a line of glue under every truss and 2 inch screws countersunk and spaced out every 8 inches. We then installed a drip edge behind the wall substrate and installed the matching wood to the walls. Then we installed metal to the corners that had gaps over a 1/4 inch to reinforce them. After that we installed a metal kick under the patio door and window. Then we installed dec corners and drip edge. Lastly we sanded down the whole area and installed dec patch to the laps.
< End Report > CODE: 10336
Contact Us: 24 Hour Emergency Roof Repair. Telephone: 1.403.873.7663. Email: firstname.lastname@example.org. Mailing: 240 – 70 Shawville Boulevard SE Calgary, Alberta. T2Y 2Z3. For all other areas of Canada call 1.877.497.3528 Toll Free. We service all areas of southern and central Alberta and south east British Columbia including Airdrie, Banff, Calgary, Canmore, Crossfield, Carstairs, Didsbury, Olds, Sundre, Three Hills, Drumheller, Hanna, Brooks, Bassano, Strathmore, Chestermere, Irricana, Cochrane, Black Diamond, Okotoks, Priddis, Bragg Creek, Cranbrook, Fernie, Panorama, High River, Vulcan, Medicine Hat, Lethbridge, Taber, Sylvan Lake, Red Deer and other Alberta rural points between.